Weldon Paints | Weldon Paints Pakistan | Weldon Paints Lahore | Weldon Paints Karachi
Oil Base Road Marking Paint
Paint for marking asphalt roads. Based on alkyd resins. Fast drying.
PRODUCT NAME:
Oil Base Road Marking Paint
USAGE:
Designed for marking asphalt and concrete roads: long lines and crossings. Also suitable for marking parking lots, halls, etc.
Spreading Rate:
4-8 m2 per Litre (depending on surface and film thickness)
Touch dry:
10-20 minutes.
Open time for traffic :
30-45 minutes. (Depends upon Temperature & thickness)
Storage Shelf life:
12 months.
COLOUR RANGE:
White, Yellow & Black
Thinner for dilution:
Thinner for road marking paint.
Gloss at 60°C:
Matt
Size Range:
According to international standard.
Roundness Rate:
Greater then 80%
Refractive Index:
Greater then 1.5
Gravity:
2.0-2.8
Appearance:
Colorless, transparent ball
Application:
Scatter glass beads immediately after paint application.
Surface Preparation and specification:
Clean road surface from dust, grease and any other foreign matter. Do not paint on a wet or damp surface, when rain is expected or in extreme weather conditions. Over rough aggregate (larger than 2 mm), or when small holes must be filled, use higher amounts of paint. Use such higher amounts of paint for application on seams or patches.
Cleaning Thinner
Thinner for road marking paint
Application remarks:
Stir well before application and while painting.
Warning:
Excessive brushing may melt the road asphalt and cause color changes in the paint (bleeding).
Cautions:
Any work that includes application and use of this product shall be performed according to the applicable Safety, Health and Environmental regulations.
Keep away from fire and sparks.
Provide adequate ventilation of the work space.
Use appropriate protective means.
Do not inhale fumes when spraying this product.
General comments
Data presented here is based on our best knowledge and expenence. We reserve the right to update and/or alter it without prior notice. Achievement of the best desired results is subject to proper application in strict conformance to our instructions and safety measures. Before application, the user should verify that the product is indeed designed for the intended usage and that the surfaces to be painted are properly prepared, and are suitable for the product's application. Practical spreading rate can vary, depending on the surface, the application mode, the painter's skill and weather conditions at the site. Assume approximately 75% of the calculated spreading rate.
Glass beads for Road Marking Paint:
Paint visibility at night can be enhanced by scattering glass beads designed for this purpose on the paint coat, immediately after paint application, while the paint is still wet, in quantities of 350-450 grams per square meter.