Weldon Paints | Weldon Paints Pakistan | Weldon Paints Lahore | Weldon Paints Karachi
Red Oxide Primer
It is a good quality air drying Red Oxide Primer suitable for interior as well as exterior surfaces.It will give excellent finish and smooth silky effect.
PRODUCT NAME:
Red Oxide Primer
USAGE:
For good adhesiopn , protection and water resistant of iron.
COMPOSITION:
Based on long oil alkyd resin and durable pigments.
MIXING RATIO:
Single pack
COVERING CAPACITY :
13-15 m2/litre/coat on non porous surfaces.
FILM THICKNESS:
25-30 microns per coat.
NO OF COATS:
Two
PACK SIZE:
Available in 0.91L, 3.64L & 14.56L packs.
COLOUR RANGE:
White
DRYING TIMES:
Depends on temperature, humidity, air movements & film thickness
Touch Dry:              2-3  Hours    
Dry to Recoat:         8 Hours   
Hard dry:                24 Hours
APPLICATION:
Brush or conventional spray..
THINNER:
Mineral turpentine
FLASH POINT:
34°C
GLOSS:
Matt
PROCESS AND APPLICATION:
Surface Preparation

Wood Surface

Ensure iron is moisture free. To remove grease, wipe with a solvent soaked rage. Dry scuff and smooth the surface with sand paper. Apply one coat of Red Oxide Primer and allow it to dry over night. Dry scuff again fill the surface if required and dry scuff once more.

New unpainted iron surfaces

Remove all dirt and grease etc by wiping with suitable solvent. Remove all the rust by scraping, chipping and wire brushing. Prime with Red Oxide Primer and allow it to dry for 24 hrs.

Previously painted iron surfaces

Clean the surface by removing all dirt and grease. Remove all loose flaky paint by scraping. For best results apply one coat of Weldon Wall Putty .It will give excellent finish and smooth silky effect.

Finishing

Stir and mix the paint to smooth consistency after thinning with mineral turpentine, apply 2-3 coats of Red Oxide Primer.