Weldon Paints | Weldon Paints Pakistan | Weldon Paints Lahore | Weldon Paints Karachi
Synthetic Enamel
An economical good quality air drying paint gives durable tough film and uniform appearance.
shade card
PRODUCT NAME:
Synthetic Enamel
USAGE:
For decoration and protection of iron and wood surfaces under interior and exterior conditions. It may also be used on dry concrete, masonry, sing boards etc.
COMPOSITION:
Based on long oil alkyd resin and durable pigments.
MIXING RATIO:
Single pack.
COVERING CAPACITY :
13-15 m2/litre/coat on non porous surfaces.
FILM THICKNESS:
20-25 microns per coat.
NO OF COATS:
Two
PACK SIZE:
Available in 0.91 liter, 3.64 liter and 14.56 liter packs.
COLOUR RANGE:
Wide range available ,See appropriate shade card
DRYING TIMES:
Depends on temperature, humidity, air movements & film thickness
Surface dry:              2-3 Hours   
Recoat able:             8-12 Hours   
Hard dry:                  24  Hours
APPLICATION :
Brush, Roller or conventional spray.
THINNER :
Mineral turpentine
FLASH POINT :
34°C
GLOSS :
High
PROCESS AND APPLICATION:

Surface Preparation

New unpainted iron surfaces
Remove all dirt and grease etc by wiping with suitable solvent. Remove all the rust by scraping, chipping and wire brushing. Prime with Weldon Primer and allow it to dry for 24 hrs.

Previously painted iron surfaces
Clean the surface by removing all dirt and grease. Remove loosely adhering or defective paint. For best results apply one coat of Weldon primer sealer .It will give excellent finish and smooth silky effect.

Wood surfaces
Ensure wood is moisture free. Dry scuff with sand paper. Apply one coat of Weldon under coat and allow it to dry over night. Dry scuff again fill the surface if required and dry scuff once more.

Finishing
Stir and mix the paint to smooth consistency after thinning with mineral turpentine, apply 2-3 coats of Weldon synthetic enamel.
PRACTICAL COVERAGE:
A guide to the practical coverage which can be achieved under normal conditions is 13 – 19 m2 /liter /coat.
PRECAUTIONS:
Keep the tin air tight when not in use.
Wash brush, scraper and other equipment with petrol or mineral turpentine.
Keep away from children.