Weldon Paints | Weldon Paints Pakistan | Weldon Paints Lahore | Weldon Paints Karachi
Wall Primer Sealer
It is a good quality air WALL PRIMER SEALER suitable for interior surfaces.It will give excellent finish and smooth silky effect wall putty is recommended to use under all Weldon emulsion top cots.
PRODUCT NAME:
Wall Primer Sealer
USAGE:
For good adhesiopn and protection of Walls and wood surfaces, it may also be used on dry concrete, masonary, sign boards,etc.
COMPOSITION:
Based on long oil alkyd resin and durable pigments.
MIXING RATIO:
Single pack.
COVERING CAPACITY :
13-15 m2/litre/coat on non porous surfaces.
FILM THICKNESS:
20-25 microns per coat.
NO OF COATS:
Two
PACK SIZE:
Available in 0.91 liter, 3.64 liter and 14.56 liter packs.
COLOUR RANGE:
White
DRYING TIMES:
Depends on temperature, humidity, air movements & film thickness
Surface dry:              2-3  Hours  
Recoat able:             8 Hours   
Hard dry:                 24  Hours
APPLICATION:
Brush or conventional spray.
THINNER:
Mineral turpentine
FLASH POINT:
34°C
GLOSS:
Matt
PROCESS AND APPLICATION:
Surface Preparation

New unpainted iron surfaces

Remove all dirt and grease etc by wiping with suitable solvent. Remove all the rust by scraping, chipping and wire brushing.Prime with WALL PRIMER SEALER and allow it to dry for 8 hrs.

Previously painted iron surfaces

Clean the surface by removing all dirt and grease. Remove loosely adhering or defective paint. For best results apply one coat of WALL PRIMER SEALER .It will give excellent finish and smooth silky effect.

Wood surfaces

Ensure wood and walls are moisture free. To remove grease, wipe with a solvent soaked rage. Dry scuff and smooth the surface with sand paper. Apply one coat of Weldon under coat and allow it to dry over night. Dry scuff again fill the surface if required and dry scuff once more.

Finishing
Stir and mix the paint to smooth consistency after thinning with mineral turpentine, apply 2-3 coats of WALL PRIMER SEALER .